Strutconfigurator
System · roof supports

Roof supports: strut on flat roofs

On a flat roof you want to keep the membrane intact. Roof support blocks carry strut channel, containment, pipes and units by their own weight, with no penetrations. In the configurator you set height and length and put containment or pipes on top.

Short answer

A roof support block is a rubber or plastic base, usually 200 × 200 mm, with a strut channel on top. It carries cable routes, pipes, HVAC units and panels on a flat roof by gravity, without penetrating the roof membrane. You set the height and channel length; the load spreads over the roof.

Roof supports: strut on flat roofsUnit / panel200h adjustableRoof block 200×200rubber, no penetrationRail 41×41HDGViewFlat roofScale1:15
roof supportsOwn drawing · to scale
  • Hosting Data stored in the EU · Frankfurt Stored with Neon (eu-central-1) · runs on the Cloudflare network
  • Privacy GDPR Data processing agreement available
  • System Brand-independent Public version · client version on your own range
  • Built by Built by NEXTRIQ 5.0 on Google · 22 reviews

What are roof supports used for?

For anything that has to sit on a flat roof without penetrating it: cable routes to solar panels, pipework from cooling plant, condensers and air handling units, and walkways. An H-frame on roof blocks lifts a route clear of the roof so water drains freely.

What should you watch?

A roof block presses on the membrane and the insulation below. The compressive strength of the roof build-up and the weight per block set how many blocks you need. Use a protection layer under the block if the membrane manufacturer requires it, and allow for wind load on tall items. The configurator calculates indicatively; a structural engineer or the roof manufacturer confirms.

  • Block about 200 × 200 mm, rubber or plastic
  • Channel 41×41 or 41×21, HDG outdoors
  • Height adjustable with threaded rod or an upright
  • Block spacing according to load and channel

Which finish for outdoors?

Hot-dip galvanised (HDG) is the outdoor standard. In salt-laden or aggressive environments choose stainless steel. Pre-galvanised material is meant for dry indoor areas and corrodes faster outdoors.

Frequently asked questions

Do you have to penetrate a flat roof for a cable route?

Not with roof supports: they sit loose on the roof and carry the load by gravity. The membrane stays watertight.

How much does a roof support block weigh?

That varies by manufacturer and type. Ask your supplier for the data; the client version of the configurator uses it.

Can an HVAC unit stand on roof supports?

Yes, on a strut frame on roof blocks. Check weight, vibration and wind load with the unit manufacturer.

Next step

See your own range in 3D.

In 30 minutes we show how your installers configure, what arrives on your side and what the client version on your range involves.

Manufacturer or wholesaler

Book a demo with Ismail

You see the configurator in your own brand and we discuss your range, systems and markets.

Reply from Ismail within one working day

Installer

Configure for free

A trapeze, frame or tray with cables in a few minutes, with a bill of materials and drawing.

Enquiry goes to a supplier · reply within one working day