Strutconfigurator
Sector · solar and roofs

Solar and roofs: routes and frames on flat roofs

Flat roofs carry solar panel cables, cooling pipes and air handling units. Everything has to stay put without making the roof leak. Strut on roof support blocks does exactly that.

Short answer

On a flat roof, lay cable routes, pipes and units on strut channel on roof support blocks, without penetrating the membrane. Use hot-dip galvanised steel outdoors, spread the load over enough blocks and allow for wind load. A covered cable tray protects cables from UV and debris.

Solar and roofs: routes and frames on flat roofsUnit / panel200h adjustableRoof block 200×200rubber, no penetrationRail 41×41HDGViewFlat roofScale1:15
solar and roofsOwn drawing · to scale
  • Hosting Data stored in the EU · Frankfurt Stored with Neon (eu-central-1) · runs on the Cloudflare network
  • Privacy GDPR Data processing agreement available
  • System Brand-independent Public version · client version on your own range
  • Built by Built by NEXTRIQ 5.0 on Google · 22 reviews

How do you route solar cables across a roof?

In a tray or on a ladder on roof blocks, with a cover against UV light and leaves. Lift the route slightly off the roof so water drains freely and the membrane is not damaged. Where the route enters the building, it ends at a roof penetration made by the roofer.

Advice for solar and roofs
RequirementAdvice
Outdoors, UVHot-dip galvanised (HDG), tray with cover
No penetrationsRoof blocks 200 × 200 mm on a protection layer
Units and pipeworkH-frame or double channel on roof blocks
WindWeight and number of blocks by calculation

Solar mounting rail or strut?

Mounting rails from solar racking systems are a product group of their own. Strutconfigurator covers the installation around them: cable routes, frames for inverters and units, and pipework. You configure that combination in one go.

Which systems do you use on a flat roof?

The configurator covers every system below. You combine them in one configuration, with one bill of materials.

  • Roof support blocks with strut channel for cable routes to the panels
  • H-frames on roof blocks for inverters, condensers and air handling
  • Cable trays with covers against UV and dirt
  • Hot-dip galvanised channel and fixings for outdoor use

Frequently asked questions

Should a rooftop cable route have a cover?

It is advisable: a cover protects cables from UV light, dirt and falling branches. Use cables rated for outdoor use.

How many roof support blocks do you need?

That follows from the load, the channel, wind load and the compressive strength of the roof. The configurator calculates indicatively; a structural engineer confirms.

Next step

See your own range in 3D.

In 30 minutes we show how your installers configure, what arrives on your side and what the client version on your range involves.

Manufacturer or wholesaler

Book a demo with Ismail

You see the configurator in your own brand and we discuss your range, systems and markets.

Reply from Ismail within one working day

Installer

Configure for free

A trapeze, frame or tray with cables in a few minutes, with a bill of materials and drawing.

Enquiry goes to a supplier · reply within one working day